Cleaning and Re sanding a Block Paved Patio in Duxford

I was called out to a house in Duxford to quote for cleaning kitchen floor tiles when the customer realised, we could also clean and re-sand block paved patios. We provided her with a quote and booked the work in alongside her kitchen tiles which I will detail in another post.

Duxford is a small village around 10 miles from Cambridge, and is an area which is rich in history. Duxford is most famous for RAF Duxford, a former RAF airfield that was used as a sector station during the Battle of Britain. Back in 1972 the Ministry of Defence began to store historically important aircraft in the hangars on the airfield and it is now used to house the Duxford Imperial War Museum .

Dirty Block Paved Patio Before Deep Cleaning Duxford

The block paved patio was looking worse for wear after the winter, what was once lovely shades of red brick was now dark and almost black in places with dirt and algae. Regular maintenance is always suggested to ensure the paving is looked after and to prevent it becoming slippery.

Dirty Block Paved Patio Before Deep Cleaning Duxford

Cleaning an outside Block Paved Patio

Our first job was to sweep the patio down to remove loose dirt and leaves.

Next job was to tackle the heavily stained areas that were treated with Tile Doctor Pro-Clean solution which was applied neat and left to soak in for fifteen minutes. Normally I would dilute Pro-Clean with water but in this case, I needed the full power of the product and even applying such a strong solution would not cause the brick pavers any harm. Whilst the Tile Doctor Pro-Clean was soaking in, I set up the high-pressure machine in my van and ran the long hose out to the garden area.

The Tile Doctor Pro-Clean was then scrubbed in by hand with a long handled scrubbing brush. The area was quite large, so this took most of the morning. The patio really was very dirty so lifting the layers of dirt took some time.

Next the block paving was deep cleaned using water delivered under high pressure from a wand supplied by our truck mounted cleaning machine. This machine can deliver water at various pressure levels, much higher than your average Karcher and makes easy work of cleaning patios. Immediately the patio started to look dramatically cleaner.

Once the block patio was done, I left it to dry and turned my attention to the decking around the other side of the house.

Re Sanding a Block Paved Patio

After a day of drying out we returned the following morning to re-sand the patio with kiln-dried sand which is essential to maintain the integrity of the patio and keeping the weeds down.

Dirty Block Paved Patio After Deep Cleaning Duxford

The renovation process worked really well, and the patio now looks as new as it did when it was laid. My customer was overjoyed with the results, hopefully the weather will enable them to get the patio furniture out so they can have lots of barbeques this year and make the most of the space.

Dirty Block Paved Patio After Deep Cleaning Duxford

 

Professional Block Paved Patio Renovation in Cambridgeshire

The post Cleaning and Re sanding a Block Paved Patio in Duxford appeared first on Cambridge Tile Doctor.

Source link

Stained Yorkstone Floor Renovated After Leak in Norton Office

We were called in by a hygiene supplies company after one of their delivery drivers had delivered some hand wash to one of their clients in Norton, Sheffield and unfortunately during delivery one of the bottles had leaked all over this York Stone floor. It had caused some staining and removed some of the sealant, so the floor now required a complete deep clean and seal.

Office Yorkstone Floor Before Cleaning Norton Sheffield

The modern building in the Yorkshire Hills close to Sheffield is the headquarters of a Bar & Pub dispensing equipment suppliers and the York Stone runs right throughout the main reception area. As it is the first impression for visitors, it was important that the floor was cleaned and restored and obviously the company were keen to put right their drivers’ accident. After visiting the property to survey the floor we arranged to carry the work out over a weekend while the employees were out of the way and no clients would be visiting.

Cleaning a Yorkstone Office Floor in Sheffield

Firstly, we protected the skirting boards, carpets and adjoining rooms so any splashes from cleaning would not damage or stain anything. Then we set about applying Tile Doctor Pro Clean diluted 1:5 with water. This was left to soak into the stone for ten minutes to lift the grime, dirt and previous sealer out of the stone. Once it had been given time to soak in the solution was scrubbed into the stone with a 40kg weighted floor buffer fitted with a 17in black scrubbing pad running at medium speed. Immediately you could see a huge change in the appearance of the stone as the natural colours of the stone were revealed.

Office Yorkstone Floor During Cleaning Norton Sheffield

When one area had been scrubbed, we vacuumed up the resulting slurry and gave the floor a thorough rinse with fresh water. The rinsed water was also extracted with the wet vacuum before moving onto another area of floor. It took a full day to clean the whole floor and then we left it to dry off fully overnight.

Office Yorkstone Floor During Cleaning Norton Sheffield

Sealing a Yorkstone Office Floor in Sheffield

We returned the following morning, the floor was checked with the damp meter to ensure it was dry enough, it was within the correct parameters, so we were good to go ahead and apply the seal.

Office Yorkstone Floor After Cleaning Damp Test Norton Sheffield

The floor was given two coats of Tile Doctor Colour Grow; this is an impregnating sealer that seeps into the pores of the stone, intensifying the natural colours in the stone whilst providing the durable surface protection needed for such a high traffic area. Each coat is left to dry before applying the next.

Office Yorkstone Floor After Cleaning Norton Sheffield Office Yorkstone Floor After Sealing Norton Sheffield

Once complete the floor looked much cleaner, the colours in the stone were much more evident and any evidence of the staining was gone. The new sealer is set to keep the floor protected from ingrained dirt for some time to come. The owners of the company were over the moon, and the driver was relieved too, as you can see from the pictures the change was dramatic. In fact, the feedback I got from the customer was.

“What a transformation!!!”

Office Yorkstone Floor After Sealing Water Test Norton Sheffield

 

Professional Restoration of Yorkstone Office Floor in South Yorkshire

The post Stained Yorkstone Floor Renovated After Leak in Norton Office appeared first on South Yorkshire Tile Doctor.

Source link

Cleaning a Flood Stained Limestone Fireplace in Chelmsford

[ad_1]

The UK has been experiencing an increasing amount of rain over the last few years and this has resulted in quite a few areas being flooded. One of those areas is the old city of Chelmsford in the middle of Essex which is prone to flooding due to the rivers Cam and Chelmer that run through the town.

Limestone Fireplace Showing Flood Staining Chelmsford

I was asked to visit a property in the town that had been flooded over winter and the red dye in the carpet that was lying on the floor adjacent to their lovely Limestone Fireplace had stained the hearth in several places but primarily around the edges.

Limestone Fireplace Showing Red Dye Staining Chelmsford

The fire place had never been sealed and because of this the stone had sucked up the flood water like a sponge. They had drying equipment installed and as the moisture evaporated the red staining became more and more evident. Since then several companies had been to try and remedy the problem and each one was unsuccessful. The couple contacted us, and we went to assess the problem fully equipped to carry out the work.

Cleaning a Dye Stained Limestone Fireplace Hearth

Had the Fireplace been sealed we our first task would have been to remove to ensure we would have no issues sealing the fireplace later. In this case however that wasn’t an issue, so we were able to move straight onto cleaning up the stone using a set of diamond encrusted hand-held burnishing blocks. We started with the coarsest block (50 grit) and rubbed the stone with a bit of added water as lubrication, before wet vacuuming away the excess residue. This process was then repeated with progressively finer blocks (100, 200 and 400 grit), and the hearths were given a final rinse with fresh water.

The burnishing blocks are excellent tools to remove scratches and marks from tile and stone and did a good job of removing the red dye from around the hearth. They also took care of some marks that had appeared where the owner had placed a couple of slate tiles on the flat part of the hearth.

Limestone Fireplace Showing Rust Stain Spots Chelmsford

Along with these marks were some corrosion spots where a metal ornament had been sitting on the hearth for several years. I treated these with Tile Doctor Rust Away which is a specialist product for removing rust stains from tile and stone after a few applications the stain was gone.

Limestone Fireplace Showing Rust Stain Spots Chelmsford

Sealing a Limestone Fireplace Hearth

After we had cleaned the fireplace up to the satisfaction of the client we used a smail dryer to dry everything out so that we could finish the job and seal the fireplace the same day. Once the stone moisture levels were at the correct level the Limestone Fireplace was sealed using three coats of Tile doctor Ultra-Seal leaving twenty minutes between coats.

Ultra-Seal is a no-sheen product that impregnates the pores of the stone protecting from within without changing the look of the stone thereby leaving it with a natural appearance. I’m please to say our efforts paid off and the Limestone Fireplace and Hearth is now stain free and looking like new.

Limestone Fireplace After Rust Stain Removal Chelmsford Limestone Fireplace After Flood Stain Removal Chelmsford

 

Dye Stained Limestone Fireplace and Hearth Restoration in Chelmsford

[ad_2]

Source link

Red Wine Stains Removed from Limestone Fireplace in Woking

[ad_1]

Here at Tile Doctor we have developed numerous products and techniques for dealing with all types of situations related to the cleaning of stone, tile and grout. Whilst the most popular work we do relates to the cleaning and sealing of floors sometimes we get asked to resolve more unusual issues such as this Wine Stained Limestone Fireplace at a house in the London commuter town of Woking.

Unfortunately for the customer their teenage son had knocked a glass of red wine from the dining table onto the carpet and over his parent’s adjacent limestone fireplace which despite early attention left noticeable dark spots in the stone. The customer was keen to have the stains removed and had even resigned himself to the possibility of replacing the whole fixture. Naturally this would’ve cost hundreds of pounds; fortunately, however he discovered Tile Doctor on the internet and realised the staining could be remedied reasonably easily with the correct knowledge and products.

Limestone Fireplace Before Wine Stain Removal Woking

Cleaning a Wine Stained Limestone Fireplace

I mentioned earlier Tile Doctor have developed numerous products and techniques and this includes Tile Doctor Reduxa which is designed to lift the stains out of stone, so I decided to try that first.

My method of application was to spray the stain with Reduxa and leave it to soak into the stone for about twenty seconds. Then I worked the solution into the surface of the stain lightly using a smooth 400 grit diamond block. The next step involves using a heat gun to dry out the area. This process is repeated five or six times until the stain completely disappears. The process works by dissolving the stain into the Reduxa which is then evaporated by the heat.

Limestone Fireplace After Wine Stain Removal Woking

I’m pleased to report that the stain was completely removed by the process and no other treatment was required to resolve the problem further. The customer still has to decide however what to do with the carpet…
 
 

Professional Removal of Wine Stains from Limestone in Surrey

[ad_2]

Source link

Stains Removed from Limestone Tiled Kitchen Floor in Tutbury

[ad_1]

First of all apologies for the quality of the photographs on this page, I clearly need to work on my photography skills. Normally photographs like these wouldn’t make the website site however they did capture the stain quite well so I thought they would be worth including. The customer who lives at a large house near Tutbury had a spillage on the lovely Limestone floor tiles in her kitchen which she tried to clean with different chemicals including bleach which just made the problem worse.

The trouble with bleach is it’s a strong acid which will eat through the sealer on your stone tiles, which in this case resulted in whitish circles you can see in the middle of the photograph below.

Limestone Tiled Kitchen Floor in Tutbury Before Stain Removal

The tiles were overdue a deep clean anyway so the owner called me in to renovate the floor and hopefully remove the staining.

Removing Staining from Limestone Tiled Floor

I started the process by giving the floor an initial clean with Tile Doctor Pro-Clean which is a strong alkaline tile cleaning product. This wouldn’t address the staining problem but my intention was to get the grout clean and also remove any surface dirt and grit from the floor. The cleaning solution was scrubbed in and then rinsed off with water which was then extracted using a wet vacuum.

The best method for restoring the appearance of Limestone floor tiles requires stripping back the surface of the tile and then building back the polish of the stone using a process we call burnishing. To do this we use a set of diamond encrusted pads which come in different grades from coarse to very fine. The pads are applied using a floor buffer machine and each pad does a different job and you start with the course red pad together with a little water and then carry on with the white, then yellow pad again using a little water removing the soiled water along the way.

Although the floor now looked great the bleach had done more damage than first anticipated and had stripped the stone of its natural oils where the spillage had been. To rectify this I applied Tile Doctor Stone Oil to the floor which I’m happy to say resolved the problem.

Sealing Limestone Tiles

Once the Stone Oil has soaked in I followed up with the application of Tile Doctor Colour Grow which is a specially designed stone sealer that penetrates into the pores of the stone protecting it from within whilst enhancing the deep natural colours in the stone. The floor was then left for about one hour to dry before working in Tile Doctor Shine powder with a white buffing pad to give a really deep robust finish.

Limestone Tiled Kitchen Floor in Tutbury After Stain Removal

The floor was transformed after I had finished and before leaving I made sure to advise the owner on the correct way to maintain her floor in future.
 
 

Polishing Limestone Floor Tiles in a Staffordshire Kitchen

[ad_2]

Source link