The client from the Bedford village of Biddenham had requested a quote to restore the look of their Limestone floor tiles which were laid throughout the whole ground floor including lounge, hallway and kitchen covering approximately 120m2 in total. The floor needed a thorough clean, filling of holes in high traffic areas followed by polishing and then sealing.
Over time, the floor in this busy household with 2 large dogs had become dirty and certainly worse for wear with all the use it had been getting. A quote was given and accepted and work was booked in to be carried out over 4 days with 2 Tile Doctor technicians on site for 2 of those days.
Deep Cleaning Limestone Floor Tiles
We returned on the agreed date and started work to get this floor back to looking its best. My initial task before beginning the cleaning process was to apply a protective wrap around the oak doors and moving heavy furniture with sliders that the client couldn’t move themselves to give us a clear area to work in.
We then applied Tile Doctor Pro-Clean, diluted with water, to the floor. Pro-Clean is a strong alkaline cleaner that is suitable for use on all natural stone floors such as Limestone, Slate and Travertine.
After leaving the solution to dwell for a few minutes, We began to scrub over sections (Approximately 10m2 at a time) with a 17” scrubbing pad fitted to a buffing machine, whilst helping to remove a lot of the built up dirt on the surface of the tiles, the products also stripped off the old sealer, this was then rinsed and removed using a wet pick up machine. Following this we paid special attention to the grout lines, scrubbing with grout brushes and Tile Doctor Grout Clean-Up.
After completing the cleaning, I rinsed the floor again with clean water to remove any excess cleaning products. I then began to burnish the floor using Tile Doctor Diamond encrusted burnishing pads. This was done in four steps, as I used four different pads (coarse, medium, fine and very fine) rinsing the floor with water between each pad. Starting with a coarse pad and then gradually working up to the very fine pad achieving a high polish finish in the process. I finished off the process with a quick rinse and a white buffing pad to give the floor a final polish before I commenced the sealing of each area the following day to allow grout and stone to fully dry overnight.
Sealing Limestone Floor Tiles
The client requested a natural look finish so my choice of sealer was Tile Doctor Ultra Seal which will protect the floor but not change the colouring in any way. The sealer penetrates deep into the pores of the stone, providing water resistance and long-term protection from ingrained dirt and stains.
This was a large area so it took some time to complete but it was well worth the effort, certainly the customer thought so and left the following feedback on the Tile Doctor Feedback System.
Phil and his team were polite, friendly and professional at all times. Nothing was too much trouble for them and they worked very diligently to ensure they got the best possible outcome and the floors l. . . ok better than new at the end.
As you can see from the comments the client was extremely happy with the results and he has asked for details of our maintenance plan to keep his floors looking their best for years to come.
Large Limestone Floor Renovation in Bedfordshire