Careful Slate Floor Renovation in Oxted

This was a very large natural Slate floor installed throughout much of the ground floor at a property in the East Surrey town of Oxted. The owner was unhappy with the state of the tiles and especially the grout, however she wanted to ensure I would take maximum care around her Baby Grand Piano. If you have read any of my previous articles you will know I am careful and take time to protect anything that could be stained or damaged with a non-marking film. I therefore assured her I would take maximum care in her home and that it wouldn’t be a problem.

I surveyed the floor and could see that the previous sealer had long since failed and dirt had penetrated the pores of the stone. This made it difficult to clean the floor effectively and resulted in a continually dull appearance. The grout had also trapped the dirt and had gone black as a result. The cure would be to strip the tile and grout of what was left of the original sealer, deep clean and then reseal. Happy with my quote we set a date for the work to start.

Slate Tiled Floor Oxted Before Cleaning Slate Tiled Floor Oxted Before Cleaning

Stripping and Cleaning Slate Floor Tiles

When I arrived on the appointed day, I discovered that the owner had gone to some lengths to pad the piano with bumble wrap mostly to prevent any airborne chemical or dust damage.

Working in sections I started applying Tile Doctor Remove and Go to the floor which is a powerful coatings remover that would strip what was left of the old sealer from the floor. The product is left on the Slate for about ten minutes before scrubbing it in with a rotary machine fitted with black pad. The machine is run at slow speed to minimise splashing and then the slurry is rinsed off the tiles with water and a wet vacuum.

I inspected the floor at this point to ensure the process was having the right effect and it became evident that there was no integrity in the grouting which was crumbling. This was a major problem and it became clear that the only way to resolve it would be to remove and replace all the grout.

Slate Tiled Floor Oxted Failing Grout

Re-grouting a Large Slate Tiled Floor

Over the next couple of days, I cut out all the existing grout with a special tool. They were large format slate tiles however with most of the ground floor needing to be re-grouted it took some time to complete. Once all the grout was removed, I set about applying fresh grout using a colour that highlighted the Slate tiles better.

Slate Tiled Floor Oxted Replacing Grout

Sealing Tumbled Slate Kitchen Tiles

Once the grout had dried, I was able to start applying a new sealer to the Slate tiles. Slate responds well to Tile Doctor Colour Grow which is an impregnating sealer that protects the stone from within. It’s also a colour enhancing product that really brings out the best in natural stone such as Slate.

Slate Tiled Floor Oxted After Renovation Slate Tiled Floor Oxted After Renovation

Two coats of Colour Grout were sufficient to seal the Slate tiles and I think you will agree the stone floor has come back to life and become a fine setting for the Baby Grand Piano.

Slate Tiled Floor Oxted After Renovation Slate Tiled Floor Oxted After Renovation

Before leaving my very happy customer to the enjoy, I left her with customer with a complimentary bottle of Tile Doctor Stone Soap, a neutral and highly reliable cleaner for natural stone floors such as Slate. This will assist her in maintaining the appearance and condition of the tiles going forward. Another satisfied customer!

 

Professional Cleaning and Sealing of Tumbled Slate Tiles in East Surrey

Source link

Jerusalem Limestone Floor Renovation in the City of York

[ad_1]

Jerusalem Stone is a pale variety of Limestone that comes from Israel and is available in different colours. It’s a high-quality material that has been used in construction for thousands of years however like all Stone used as flooring, it benefits from being sealed to prevent dirt from becoming ingrained in the stone.

Jerusalem Limestone Before Cleaning York

This ground floor of this house in the historic walled city of York had around 60 metres of Jerusalem Limestone installed throughout the kitchen area and some adjacent steps. Its appearance had degraded with use and was now looking flat, dirty and generally uninviting. Additionally, the customer didn’t like the natural pitting in the stone which proved to be a trap where dirt became ingrained making it more difficult to clean.

Jerusalem Limestone Before Cleaning York

I surveyed the floor and discussed the process required to restore the floor including restoration work to fill the pitting. I also worked out a price which was agreed and booked a date in the diary for the work to be done.

Cleaning and Filling a Jerusalem Limestone Tiled Kitchen Floor

My first task was to fill the holes using three different colours of grout. The floor was a mixture of shades, so I chose the best match based on the different colours in the stone. This work was tedious and a little slow but worked well and I was very pleased with the result. I come from a Tiling background so am quite used to working with grout in this manner.

Jerusalem Limestone Before Filling York Jerusalem Limestone After Filling York

Next the floor was deep cleaned with the 400, 800 and 1500 grit diamond burnishing pads fitted to a weighted floor buffer and lubricated with water. The pads are applied in sequence starting with the 400-grit pad first and the soil generated is rinsed off with water in-between. This process removes grease marks, old sealers, ingrained dirt and builds the polished finish of the limestone. I also used a hand-held burnishing block on the steps to get into the intricate corners.

The grout was particularly dirty and was cleaned by hand using Tile Doctor Pro-Clean scrubbed in with a narrow stiff brush and the soil rinsed off with water and extracted with a wet vacuum. This product is a multi-purpose cleaner and degreaser and it really gets to work on the hard to shift build-up of dirt, grime and grease.

The floor was left to dry off overnight, the lovely warm weather was a blessing as the floor was pretty large, thankfully we didn’t need to install any driers on this occasion.

Jerusalem Limestone During Grout Cleaning York

Sealing a Limestone Tiled Kitchen Floor

I returned the next day to finish the polishing with the final 3000-grit pad applied with a little water sprayed onto the tile. once done I tested the floor with a damp meter to make sure it was nice and dry and ready for sealing. The filled areas were looking particularly good, eliminating the issue the customer was having with dirt getting stuck in them.

To seal the Jerusalem Limestone and protect it from ingrained dirt I used two coats of Tile Doctor Ultra-Seal which is a natural look sealer that doesn’t alter the appearance of the stone. As well as providing the natural no-sheen look that the customer wanted it will provide stain protection and is recommended for food preparation areas such as kitchens. It also was excellent for sealing the grout and the areas I had filled.

Jerusalem Limestone After Cleaning York

The customer was very happy with the result and couldn’t believe how fast we had worked to restore the floor. She was relieved it would now be much easier to clean and maintain.

Jerusalem Limestone After Cleaning York

 

Professional Restoration of a Limestone Tiled Kitchen in North West Yorkshire

[ad_2]

Source link

Renovating Jerusalem Limestone Kitchen Tiles in York

[ad_1]

Jerusalem Stone is a pale variety of Limestone that comes from Israel and is available in different colours. It’s a high-quality material that has been used in construction for thousands of years however like all Stone used as flooring, it benefits from being sealed to prevent dirt from becoming ingrained in the stone.

Jerusalem Limestone Before Cleaning York

This ground floor of this house in the historic walled city of York had around 60 metres of Jerusalem Limestone installed throughout the kitchen area and some adjacent steps. Its appearance had degraded with use and was now looking flat, dirty and generally uninviting. Additionally, the customer didn’t like the natural pitting in the stone which proved to be a trap where dirt became ingrained making it more difficult to clean.

Jerusalem Limestone Before Cleaning York

I surveyed the floor and discussed the process required to restore the floor including restoration work to fill the pitting. I also worked out a price which was agreed and booked a date in the diary for the work to be done.

Cleaning and Filling a Jerusalem Limestone Tiled Kitchen Floor

My first task was to fill the holes using three different colours of grout. The floor was a mixture of shades, so I chose the best match based on the different colours in the stone. This work was tedious and a little slow but worked well and I was very pleased with the result. I come from a Tiling background so am quite used to working with grout in this manner.

Jerusalem Limestone Before Filling York Jerusalem Limestone After Filling York

Next the floor was deep cleaned with the 400, 800 and 1500 grit diamond burnishing pads fitted to a weighted floor buffer and lubricated with water. The pads are applied in sequence starting with the 400-grit pad first and the soil generated is rinsed off with water in-between. This process removes grease marks, old sealers, ingrained dirt and builds the polished finish of the limestone. I also used a hand-held burnishing block on the steps to get into the intricate corners.

The grout was particularly dirty and was cleaned by hand using Tile Doctor Pro-Clean scrubbed in with a narrow stiff brush and the soil rinsed off with water and extracted with a wet vacuum. This product is a multi-purpose cleaner and degreaser and it really gets to work on the hard to shift build-up of dirt, grime and grease.

The floor was left to dry off overnight, the lovely warm weather was a blessing as the floor was pretty large, thankfully we didn’t need to install any driers on this occasion.

Jerusalem Limestone During Grout Cleaning York

Sealing a Limestone Tiled Kitchen Floor

I returned the next day to finish the polishing with the final 3000-grit pad applied with a little water sprayed onto the tile. once done I tested the floor with a damp meter to make sure it was nice and dry and ready for sealing. The filled areas were looking particularly good, eliminating the issue the customer was having with dirt getting stuck in them.

To seal the Jerusalem Limestone and protect it from ingrained dirt I used two coats of Tile Doctor Ultra-Seal which is a natural look sealer that doesn’t alter the appearance of the stone. As well as providing the natural no-sheen look that the customer wanted it will provide stain protection and is recommended for food preparation areas such as kitchens. It also was excellent for sealing the grout and the areas I had filled.

Jerusalem Limestone After Cleaning York

The customer was very happy with the result and couldn’t believe how fast we had worked to restore the floor. She was relieved it would now be much easier to clean and maintain.

Jerusalem Limestone After Cleaning York

 

Source: Limestone Tile Cleaning and Sealing Service in York

[ad_2]

Source link