Stained Limestone Tiled Wet Room Renovated in Sonning Eye


This enquiry came from a theatre buff at a house in Sonning Eye near Reading who regularly hosted cast members playing at the local Mill Theatre. Five years prior he had a Limestone tiled wet room installed and unfortunately the floor tiles were laid unevenly and the fall on the tiles didn’t allow the water to drain off efficiently. The water would therefore tend to pool in the centre and overtime heavy limescale built-up and mould had also started to appear.

Limestone Shower Before Renovation Sonning Eye

Cast members staying at his house although grateful of the hospitality had often mention the state of the unsightly shower and so we were asked to pop round and see what could be done to renovate it and restore its appearance.

Shower Tile and Grout Cleaning

The first task was to remove the mould that had ingrained the Limestone, to do this I used Tile Doctor Duo Clean and scrubbed it into the tile with assistance from a steamer. I repeated this action three times, after each time I could see a visible improvement in the affected area and once it had lightened to a very faint grey, I knew that the next cleaning process to burnish the stone would see it disappear completely so left it at that.

Limestone Shower During Renovation Sonning Eye Limestone Shower During Steam Cleaning Sonning Eye

Next job was to remove the limescale build-up and re polish the Limestone tiles. I found the best way to do this was with a small hand-held machine, this allowed me to get into all the edges and groves that would have been impossible with a larger machine which would have struggled to cope with the uneven tiles.

Limestone Shower During Polishing Sonning Eye

I started with a 400-grit burnishing pad, but this struggled to cut into the years limescale build-up, so I switched this for 100-grit soft milling pad which did the trick. Once all the limescale had been removed it was time to rebuild the polish on the surface of the stone, so the process was repeated working through finer and finer burnishing pads 200, 400, 800,1500 and finally 3000-grit until the appearance of the Limestone was restored. This is quite a time-consuming process as the pad are quite small, additionally each pad is applied with water to provide lubrication which turns into a slurry that has to be rinsed off before applying the next pad. The result however is worth at as it really restores the polished appearance of the Limestone.
The last part of the cleaning process was to give the grout a quick clean I did this by scrubbing in Tile Doctor Pro-Clean along the grout lines with a grout brush, again rinsing off the slurry afterwards. Pro-Clean is a strong alkaline tile and grout cleaner that’s safe to use on natural stone.

Sealing Limestone Tiles in a Wet Room

The final task was to seal the Limestone and replace the worn mastic/silicon sealant around the edges. Usually I would leave the stone to dry out overnight but as it was a small area, I was able to thoroughly dry it out using a heat gun. Once dry two good coats of Tile Doctor Ultra-Seal were applied to provide on-going protection. Ultra-Seal is an impregnating sealer that works by occupying the small pores in the stone thereby preventing dirt from becoming ingrained, also it doesn’t change the colour of the stone in any way leaving a very natural appearance.

Last step before finishing was to apply a fresh application of white mastic sealant along the edges of the tiling to ensure a good seal and no leaks.

Limestone Shower After Renovation Sonning Eye

My customer was over the moon with the result as initially he thought he might have to have it replaced. He was so pleased in fact that he left the following feedback on the Tile Doctor feedback system.

“Excellent prompt and courteous service from Dennis who I cannot recommend too highly. After completion of the work a previously very tired looking wet-room looked better than it did when new.”

Limestone Shower After Renovation Sonning Eye

 

Professional Stone Tiled Wet Room Renovation in Berkshire



Source link

Removing Limescale from Slate Shower Tiles in Oxshott


In the south east of England, we suffer from hard water which as many of you have experienced can calcify on our showers leaving white limescale staining. Without fitting a water softener this limescale causes a problem around the home, particularly when the tiles are dark.

A good example of this problem was this large dark grey slate tiled shower at a house in Oxshott where the limescale had completely ruined the look of the black slate. The problem was most evident on the slate tiles on the floor but had also stained the slate split face slate tiles on the shower wall.

Slate Tiled Bathroom Before Renovation Oxshot

Oxshott is a village in Surrey between Leatherhead and Esher, a survey in 2010 by the Daily Telegraph asserted it was “the village with most footballers” in England and mentioned other celebrities who chose to live in the village probably because Chelsea Football Club have their main training ground in nearby Stoke D’Abernon; It is a beautiful area and is no surprise it is also known as ‘the most expensive village in England’.

The wet room was not that old, but due to the limescale staining was prematurely in need of attention. We often get calls from customers where they have use supermarket products to treat hard water stains, however these products are generally acidic, and this can make the problem worse. I would recommend you always read the back of the bottle before to check it is safe to use on natural stone before applying.

After inspecting the shower, I agreed with the client the best course of action, agreed a price and booked the job in for a later date.

Limescale Stained Slate Wet Room Cleaning

I returned on the agreed date and started work by first removing the existing sealer by applying Tile Doctor Remove and Go which is a multi-purpose stripper that’s formulated for use on natural stone. The product also draws out ingrained stains and removes heavy grease build-up. For best results spray the product onto the tile and then leave for it to soak in and get to work breaking down the coatings etc. After ten minutes the product is scrubbed into the stone which in this case meant by hand. The soiled solution can then be rinsed off the tiles with water. The grout was then cleaned by hand scrubbing in a strong dilution of Tile Doctor Pro-Clean followed by more rinsing.

The final part of preparation was to remove the limescale. This was done with a small handheld diamond block and a wire brush. The block is great for smoothing down all sorts of issues and being small it can get into tight areas. I then dried the whole room with an industrial blower. Slate cannot be sealed effectively when damp as it won’t cure properly. The blower is noisy but best in this situation and is very effective when a fast dry is needed.

Sealing a Slate Tiled Bathroom in Oxshott

After lunch I checked the area was nice and dry by testing the moisture content. I then sealed the whole area, wall and floor with Tile Doctor Colour Grow. Colour Grow, is a colour intensifying sealer that provides durable surface protection as well as allowing the surface to breath and enhance colour. For this project it darkened the tiles nicely and will provide protection from staining, making them much easier for the client to maintain moving forward.

The client was very happy with the lovely result. The bathroom looked clean and fresh again, now it is just a case of trying to keep on top of the limescale.

Slate Tiled Bathroom After Renovation Oxshot

 

Limescale removed from Slate Tiled Shower Wall and Floor in West Surrey



Source link

Travertine Wet Room with Leakage Problem Restored in Harrogate


Travertine is a distinct and highly aesthetic material which offers unique characteristics and colouring that not many other types of stone can offer. It looks great when used on tiled floors and in this case shower cubicles however like any natural stone it does need maintenance.

Travertine WetRoom Harrogate Before Cleaning

A good example of this point was this Travertine wet room in Harrogate, which comprised of large format Travertine tiles on the floor and Travertine mosaic tiles on the walls. It was in poor condition and to make things worse had been leaking for years. A local plumber had tried to resolve the leak, but to no avail. At this point, the property owner was desperately searching for a solution, and decided to contact me to see what could be done both to restore the appearance of the wet room and fix the leakage.

Travertine WetRoom Harrogate Before Cleaning

Cleaning a Travertine Tiled Wet Room

On first inspection of the wet room, l couldn’t see any obvious problems that might be causing the leak, however the white silicon did look a bit questionable and had already decided that would need replacing. To start I turned my attention to cleaning the whole shower cubicle, including the tile and grout.

I did this by applying Tile Doctor Pro-Clean, which is a high alkaline cleaner, to remove the mould, soap scum and dyes caused by daily exposure to acidic soap and shampoos. These issues can build up exceptionally quickly if care is not taken to regularly rinse down the shower after each use.

During this process, I noticed grout haze had been left on the surface of the tiles following installation and so treated the problem with Tile Doctor Acid Gel, which is a blend of hydrochloric and phosphoric acid in gel form. Being a gel, this product works particularly well on vertical surfaces because it is easier to control.

The next step was to resolve the leakage problem, starting by removing all the old and unattractive white silicon. When l removed the silicon, I could see that it was black with mould at the back. It was clear to me then that water was getting behind it and this was the cause of the leak. Also, this revealed a 2-3mm gap between the wall and the base of the shower. The gap was damp and mould had collected there, so this needed to be scraped out manually and the gap dried with a heat gun. Finally, l filled the gap with grout to seal it and left the wet room to dry overnight.

Travertine WetRoom Harrogate Before Cleaning

Sealing a Travertine Tiled Wet Room

The next day, I returned to the property and sealed the grout with Tile Doctor Ultra-Seal. This is a premium, natural-look, penetrating sealer formulated to provide maximum stain protection and allow moisture vapour transmission. To finish the restoration, I applied fresh, clear silicon around the base.

Travertine WetRoom Harrogate After Cleaning

In my opinion, white silicon should never have been used with stone, as clear silicon is far more suitable and more pleasing to the eye. Certainly, my customer agreed – and she was very pleased with the result and no more leak.

Travertine WetRoom Harrogate After Cleaning
 
 

Professional Restoration of a Travertine Tiled Wet Room in North Yorkshire



Source link