Dirty Victorian Tiled Hallway Deep Cleaned and Sealed in York


As promised below are the photographs from the second floor I cleaned recently at a house in historic city of York. If you recall the first floor was Mexican Terracotta which proved pretty tough to clean as the rotary floor scrubber I use struggled to cope with the bull nose edges. You can find the article I created for that floor via the link below:

Mexican Terracotta Tiles Deep Cleaned in York.

The second floor was a Victorian tiled hallway which like its neighbour was dull, lifeless and now overdue a deep clean to remove ingrained dirt, part worn sealer and then reseal.

Victorian Tiled Hallway Floor Before Cleaning York

Cleaning Victorian Tiles Tiles

As with the Terracotta tiles I cleaned the floor using a strong 1:3 dilution of Tile Doctor Pro-Clean with water. This is a strong dilution ratio which will not only clean the tile but also strip off what was left of the original sealer. You need to do this as the sealer will wear off first in the most commonly used part of the floor first which in this case is down the middle of the hallway. I left the solution it to soak into the tile for about ten minutes before scrubbing it in with a black scrubbing pad fitted to a rotary floor machine. I the scrubbed along the grout lines with more pro-clean and a stiff narrow brush by hand to ensure the grout was also clean.

The floor was rinsed with water and the soiled cleaning solution was extracted using a wet vacuum. I could then see those area’s that needed more work and re-treated them with more Pro-Clean until I was satisfied all the previous sealer was gone and the tile and grout was as clean as it could be.

The tiles were given a final rinse with water and the wet vacuum used again to extract as much moisture off the floor as possible. The next step would be to seal, however the Terracotta floor tiles needed a longer drying time so I left both floors to dry out for two days before returning.

Sealing Victorian Tiles Tiles

Upon my return to the property I ran some quick damp tests, which revealed the tiles were ready to be sealed. I then applied four coats of Tile Doctor Seal and Go which provided a beautiful satin finish that really improved the look of Victorian Tile.

Victorian Tiled Hallway Floor After Cleaning York

The hallway tiles now looked clean and much brigher, needless to say my customer was very happy with the transformation.
 
 

Victorian Tiled Hallway Deep Cleaned and Resealed in Yorkshire



Source link

Original Victorian Tiled Hallway Brought Back to Life at an Esher Flat


Esher is a small suburb in Surrey, situated just outside London. It was a fashionable area to live in amongst royalty and the aristocracy in the Victorian period, and during this time many buildings were built.

One such building has since been turned into a block of separate flats, and some of the flats still contain the original Victorian tiles in the hallway. I was contacted by one of these flat owners about restoring their tiles back to the best possible condition. Interestingly this customer’s tiles were part of a larger floor that had been divided between two flats.

Victorian Floor Tile Before Cleaning Esher

Cleaning Original Victorian Tiles

I began the restoration by spreading Tile Doctor Remove and Go across the entire set of tiles. Remove and Go is a heavy-duty stripper that helped to loosen and remove old glue deposits where carpet had been laid over the tile, it will also strip off old sealers and release ingrained muck.

The Remove and Go was worked into the tile and grout with a stiff brush and then the soiled solution rinsed off and extracted using a wet vacuum. I followed by this applying a coarse 200-grit diamond encrusted burnishing pad, fitted to a handheld buffer, to grind away the particularly stubborn dirt and stains to restore the appearance of the stone. Afterwards, I rinsed the tiles again with water and soaked up the resultant slurry with a wet vacuum.

I noticed that there remained several ingrained stains dotted across the floor, so to remove these I aggressively burnished the affected areas with a very coarse 50-grit handheld diamond block. This essentially removed the very top layer of the stone, taking with it the ingrained marks.

Next, I dried the area with a large blower and heat gun. Under normal circumstances, 48 hours needs to pass before the tiles can be sealed, but as this was a small area I was able to dry it very quickly. After carrying out a damp test, I determined the tiles were ready to be sealed.

Sealing Original Victorian Tiles

To seal the Victorian Tiles, I applied six coats of Tile Doctor Seal and Go sealer, which provides a high-quality sheen finish, as well as plenty of protection for the future. Tile Doctor have a range of suitable sealers available including Colour Grow which provides a matte finish – it’s just a matter of personal choice for the customer.

Victorian Floor Tile After Cleaning Esher

The outcome of the restoration was fantastic and the customer was very pleased, leaving the following testimonial.

“Promptly organised, delivered when promised. Good looking job when complete. Well done.”
 
 

Professional Tile Cleaning and Sealing for an Original Victorian Tiled Floor Restoration in Esher



Source link