Looking at the pictures below you might think this Quarry Tiled kitchen floor at a cottage in Rotherfield was as old as the village which dates back to the 8th Century and is mentioned in the Doomsday book. It really was in a bad state with I don’t know what covering the tiles which had gone black as a result but were actually very pretty as you will see later.
The client was having a new kitchen fitted and wanted the tile and grout restored so as not to incur the cost of replacing it. This really is the best time to look at getting your tiles thoroughly cleaned as with many of the old units removed I could access most of the floor and of course I didn’t need to worry about protecting the units either.
Cleaning Dirty Kitchen Quarry Tiles
I could see this floor was going to be a challenge so decided to try a strong cocktail of Tile Doctor Pro-Clean and Nanotech HBU, HBU stands for Heavy Build-Up so quite appropriate I thought. Working in sections the floor was soaked in the cleaning cocktail and left to dwell for some time in order to soften the dirt and grime.
The next step was to run over the tiles with a set of Burnishing pads which are encrusted with industrial diamonds. It took more than one attempt at this process but the abrasive pads had the desired effect and eventually revealed the beautiful quarry flooring below.
The pads are effective on the tiles but the grout sits a little lower and so to reach these a stiff brush was scrubbed into the grout by hand.
To remove the dirt that was released from the cleaning process and further clean the tiles I used a Spinning Tool through the process. The tool is powered from a large compressor that sits in my van which forces hot water under pressure onto the tiled floor whilst simultaneously extracting the dirty water back to a tank on the van. It’s an amazing tool that is very effective however you do need to have the van parked very close the house due to a limitation on the hose lengths.
With the tiles now clean and rinsed with water the floor was dried as much as possible with a wet vacuum.
Sealing Kitchen Quarry Tiles
The floor was left to dry for a couple of days before I returned to complete the restoration with the application of a sealer. I tested the floor with a damp meter on my return to ensure it was dry; all was well so I moved onto sealing. Sealer of choice on this occasion was Tile Doctor Seal and Go which is a water-based sealer which so it doesn’t leave a smell as it dries. The Quarry tiles were quite porous, which is not uncommon for Quarry Tiles and six coats of sealer were required in the end.
As the photographs show, the floor was transformed and my customer was elated with the results saying “wow it’s like new!”