Red and Brown Marble Tiled Kitchen Floor Polishing Weybridge


If you have a Mable tiled floor which is not looking its best, then the transformation I achieved on this floor at a property in Weybridge will definitely be on interest. Having first spoken with the owner on the phone I went over to the house to take a better look at the floor and found that the deep red and brown Marble tiled kitchen floor was really dirty and totally lacking in colour or polish.

The floor hadn’t been professionally cleaned for some time and was now dirty and suffering from the actions of a puppy which likes to charge up and down. The Marble was also full of holes which the client explained had been getting larger. This is not usual for natural stone as it can be very sensitive to acidic cleaning products which if used constantly over time will start to dissolve the stone.

We discussed the remedies available, agreed a cost and arranged a mutually convenient time to carry the work out. I always like to do a site visit to survey the tiles and ideally run a test clean to determine the best methods for resolving the problems. This enabled me to give a more accurate quote and it also gives the customer confidence in my abilities.

Marble Tiled Floor Before Polishing Weybrige

Deep Cleaning Red and Brown Marble Kitchen Tiles

Firstly, I removed the existing sealer with a 400-grit diamond burnishing pad which is applied with water. Although this initially appears to make the floor look worse, this is only temporary, sometimes you have to make it look a little worse before it can get better! Once this was done the floor was rinsed with water to remove the slurry generated and this was then extracted off the floor with a wet vacuum.

Then for the next couple of hours I worked my way from the back door to the front filling all holes with a special expanding resin, then smoothing off as I went to ensure the smoothest of finish could be achieved. Some of the holes were indeed quite large, so there was quite a lot of work to do.

Once the filler had dried I started the polishing process using the 800 and then 1500 grit burnishing pads, once again with more water to lubricate and rinsing the floor in between polishing and removing the slurry as before. This process took much of the day, so I left the floor to dry off and came back the next day to complete the polishing and seal the Marble.

Sealing Red and Brown Marble Kitchen Tiles

The next day I returned and completed the polishing process by applying the fourth burnishing pad which is an extra fine 3000 grit pad, you apply the pad dry with only a little amount of water sprayed onto the floor in process we call a spay burnish and this final pad really brings up the polish in the Marble.

Once the polishing had finished I left the floor for a little while to make sure it was nice and dry and then I applied two coats of Tile Doctor Colour Grow sealer. This is a colour intensifying sealer that provides durable protection by impregnating the pores in the stone with sealer, so dirt cannot become ingrained there. As you can see from the pictures the sealer dramatically enhanced the natural colours in the stone.

Once dry I backed my way out of the house with a final finishing polish using a white buffing pad to remove any excess sealant and bring up the sheen of the tiles even further. I left instructions with the client to keep off for a couple of hours while the sealer cured.

The client was over the moon with the end result, the floor was left shiny, protected and looking in a fabulous condition.

Marble Tiled Floor After Polishing Weybrige

 

Professional Restoration of a Marble Tiled Kitchen Floor in West Surrey



Source link

Restoration of Viakal Damaged Marble Shower Tiles in Ealing


We were recently received an enquiry from a customer in Ealing, East London who was concerned about their Marble Tiled Shower which had been damaged from the use of Viakal Limescale Remover. Unfortunately, this is a very common problem and we often receive calls from customers with similar issues. Limescale removal products such as Viakal and Cillit Bang are very effective but like any acidic product, they are very harmful to natural stone such as Limestone and Marble. With any cleaning product you should really read the label before use and in this case you will find they state the product should not be used on natural stone.

The Viakal had etched the surface of the Marble in several places where it had been applied and although the damage looked really bad I was happy to inform my customer there is a solution and that I could indeed restore the appearance of the stone.

Damaged Marble Shower Wall Before Restoration Ealing Damaged Marble Shower Wall Before Restoration Ealing

Polishing Damaged Marble Shower Tiles

My first task was to give the Marble tile and grout a good clean and remove any sealer and soap scum etc; to do this I used a strong dilution of Tile Doctor Pro-Clean scrubbed in with a small black scrubbing pad fitted to a hand-held machine. The Marble tiles were then rinsed with water to remove the soil generated by the cleaning process.

To fully restore the appearance of the Marble the next step required the application of coarse burnishing pads applied in sequence from very coarse to very fine using six-inch pads fitter to a handheld buffer. It’s a process that takes the polish off the stone and rebuilds it. A little water is needed to help lubricate with the coarser pads and the tiles are rinsed off between each one to remove any slurry generated during the process.

To achieve a very high shine the Marble tiles were then treated to an application of Tile Doctor Shine Powder which involves buffing crystallising polishing powder into the stone to build a deep durable finish

Sealing Marble Shower Tiles

The last step was to seal the Marble tile and grout to protect it going forward. Before sealing we needed to make sure that the tiles are dry and a damp meter is a very useful tool for this. A single coat of Tile Doctor Colour Grow was applied which is an impregnating sealer that occupies the pores in the stone whilst enhancing the natural colours in the Marble in the process.

Damaged Marble Shower Wall After Restoration Ealing Damaged Marble Shower Wall After Restoration Ealing

The work took three days in total but as you can see from the photographs on this page it was well worth the effort and the white streaky damage caused by the Viakal has now been removed and the stone has been transformed. My customer was very happy with the results and left the following feedback.

I had serious acid etchings from spraying Viakal on my marble shower box and basin. Didi and his partner did a good job of polishing out the majority of the acid etchings. It was a 3 day job for them, and over all I was happy with the result and service.
Edward T, London

 
 

Acid Etched Marble Shower Tiles Restored in London



Source link