Ruined Marble Shower Tiles Restored in Sharnbrook


I was contacted by the owner of a cleaning company in Milton Keynes, after an end of tenancy clean at a house in Sharnbrook went wrong. Unfortunately a member of their staff had incorrectly applied an acid based cleaning product to the Marble shower tiles which like most natural stone is acid sensitive. The cleaning product had etched the stone causing the damage you can see below. Being a reputable company they were determined to put the situation right and we were asked to step in.

Marble Shower Cubicle Before Cleaning in Sharnbrook

We have had a few issues of this type before where customers keen to remove unsightly Limescale marks from their stone tiles use a household cleaner without reading the bottle label first to see if it’s safe to use. Issues of this nature on Marble cannot be easily resolved with chemical products; it takes specialist knowledge and equipment.

Marble Shower Cubicle Before Cleaning in Sharnbrook

The quote was given and accepted and the work was booked in with the letting company for a few weeks later.

Cleaning and Polishing a Marble Shower Cubicle

The first photos show the extent of the damage which had not only damaged the immediate area but as the cleaning product was in liquid form it had ran down the wall had totally ruined the surface of the tiles in the lower half of the shower.

The first thing I did was to protect the shower tray with towels and then began assembling the equipment needed for this job which consisted of a wet polisher, a variable speed polisher, one set of 6” Tile Doctor burnishing pads from 100 grit to 3,000 grit and one full set of diamond blocks from 80 grit upwards.

I then went about testing how far down the scale I would have to go to get the best results. I found that in most areas the application of a 200 grit burnishing pad was adequate to resurface the tile and remove damage but in some areas I had to go down the scale as low as 80 grit to achieve the desired result.

Marble Shower Cubicle During Cleaning in Sharnbrook

One the damage had been removed the higher grit pads are used in sequence to restore the polish finishing with the 3,000 grit pad. No chemicals are used in this process, just water and the small six inch diamond encrusted burnishing pads which fit to a hand buffer.

Although only a small area, no more than 4 m2 this job took most of the day. However, as the whole shower room was tiled in the same tiles it was a much more cost effective to restore the damaged tiles than replace them.

Marble Shower Cubicle After Cleaning in Sharnbrook

We were able to achieve an excellent result which the client was very happy with, no doubt saving the cleaning company thousands of pounds in replacement costs.

Marble Shower Cubicle After Cleaning in Sharnbrook
 
 

Professional Restoration of a Damaged Marble Tiled Shower Cubicle in Bedfordshire



Source link

Slate Tiled Shower Cubicle Ruined by Limescale Renovated in Wantage


This house in Wantage was on the market to be sold but many potential buyers had been put off by the poor condition of the Slate tiled shower cubicle. Wantage is a lovely little market town in the south of Oxfordshire and a desirable location to live.

However, before this house could be sold, the shower cubicle needed to be renovated; as you can see from the photos below, there was a heavy build-up of limescale that needed to be removed.

Slate Tiled Shower in Wantage Before Cleaning Slate Tiled Shower in Wantage Before Cleaning

With the property owner keen to sell the house, he asked me to get the shower cubicle back to looking its very best. This would involve a deep clean, acid wash and seal.

Cleaning Limescale Damaged Slate Shower Tiles

To begin the restoration, I cleaned the walls using Tile Doctor Pro Clean. This is a strong alkaline product which is powerful and sage to use on natural stone to eradicate dirt and residue that has built up over time. I scrubbed the Pro Clean into the tiles and grout lines, before rinsing the entire area with fresh water.

The next stage involved removing the heavy build-up of limescale. This was done using Tile Doctor Acid Gel, which is a blend of phosphoric and hydrochloric acids in gel form. Being in this form makes it especially effective for use on sloped and vertical surfaces as it it’s easier to control and can dwell for a long time where required. The product deals with alkaline-based limescale and mineral salt deposits (efflorescence).

I scrubbed the Acid Gel into the affected areas with a stiff nylon brush, before rinsing with fresh water. I then needed to repeat this process twice more to make sure all the limescale was completely removed. Following this, I left the shower to dry before sealing.

Sealing Slate Shower Tiles

After letting the shower cubicle tiles dry, I sealed them using Tile Doctor Colour Grow, which is an impregnating, colour-enhancing sealer.

The sealer is specially formulated to really emphasise the different natural tones and shades in the stone, in turn lifting the appearance of the entire room. In this situation, two coats of Colour Grow were used to provide robust, long-lasting protection.

Slate Tiled Shower in Wantage After Cleaning and Sealing Slate Tiled Shower in Wantage After Cleaning and Sealing

The customer was very impressed with the finished result and I’m sure any prospective property buyers will be equally impressed by the feature bathroom! Another satisfied client.
 
 

Restoration of a Limescale Damaged Slate Tiled Shower Cubicle in Oxfordshire



Source link