Removing Limescale from Slate Shower Tiles in Oxshott


In the south east of England, we suffer from hard water which as many of you have experienced can calcify on our showers leaving white limescale staining. Without fitting a water softener this limescale causes a problem around the home, particularly when the tiles are dark.

A good example of this problem was this large dark grey slate tiled shower at a house in Oxshott where the limescale had completely ruined the look of the black slate. The problem was most evident on the slate tiles on the floor but had also stained the slate split face slate tiles on the shower wall.

Slate Tiled Bathroom Before Renovation Oxshot

Oxshott is a village in Surrey between Leatherhead and Esher, a survey in 2010 by the Daily Telegraph asserted it was “the village with most footballers” in England and mentioned other celebrities who chose to live in the village probably because Chelsea Football Club have their main training ground in nearby Stoke D’Abernon; It is a beautiful area and is no surprise it is also known as ‘the most expensive village in England’.

The wet room was not that old, but due to the limescale staining was prematurely in need of attention. We often get calls from customers where they have use supermarket products to treat hard water stains, however these products are generally acidic, and this can make the problem worse. I would recommend you always read the back of the bottle before to check it is safe to use on natural stone before applying.

After inspecting the shower, I agreed with the client the best course of action, agreed a price and booked the job in for a later date.

Limescale Stained Slate Wet Room Cleaning

I returned on the agreed date and started work by first removing the existing sealer by applying Tile Doctor Remove and Go which is a multi-purpose stripper that’s formulated for use on natural stone. The product also draws out ingrained stains and removes heavy grease build-up. For best results spray the product onto the tile and then leave for it to soak in and get to work breaking down the coatings etc. After ten minutes the product is scrubbed into the stone which in this case meant by hand. The soiled solution can then be rinsed off the tiles with water. The grout was then cleaned by hand scrubbing in a strong dilution of Tile Doctor Pro-Clean followed by more rinsing.

The final part of preparation was to remove the limescale. This was done with a small handheld diamond block and a wire brush. The block is great for smoothing down all sorts of issues and being small it can get into tight areas. I then dried the whole room with an industrial blower. Slate cannot be sealed effectively when damp as it won’t cure properly. The blower is noisy but best in this situation and is very effective when a fast dry is needed.

Sealing a Slate Tiled Bathroom in Oxshott

After lunch I checked the area was nice and dry by testing the moisture content. I then sealed the whole area, wall and floor with Tile Doctor Colour Grow. Colour Grow, is a colour intensifying sealer that provides durable surface protection as well as allowing the surface to breath and enhance colour. For this project it darkened the tiles nicely and will provide protection from staining, making them much easier for the client to maintain moving forward.

The client was very happy with the lovely result. The bathroom looked clean and fresh again, now it is just a case of trying to keep on top of the limescale.

Slate Tiled Bathroom After Renovation Oxshot

 

Limescale removed from Slate Tiled Shower Wall and Floor in West Surrey



Source link

Victorian Tiled Hallway Hidden Under Carpet Restored in Leatherhead


This customer who owned a lovely period residence in Leatherhead had pulled up an old hallway carpet to discover this gem of Victorian Tiled floor. The tiles were covered in carpet adhesive, paint splashes and what looked like a hundred years of dirt. I suspect the previous owners felt it was easier to cover the hallway in carpet rather than have it cleaned properly or perhaps it was just the trend at the time.

Victorian Tiled Hallway Before Restoration in Leatherhead

Given the obvious amount of work that would be needed to restore it we got a call to pop round and provide an estimate. We do a lot of Victorian floor restorations and across the Tile Doctor network I’m confident in saying there is a Tile Doctor working on a Victorian Tiled floor every day of the week.

Victorian Tiled Hallway Before Restoration in Leatherhead

The owner was happy with the quote and we agreed a date to return and restore the floor.

Cleaning a Heavily Soiled Victorian Tiled Floor

Working in a metre square area at a time, I first applied a solution of Tile Doctor Oxy-Gel and left it to dwell for twenty minutes. Oxy-Gel is a relatively new product that being in Gel form is easy to control and stays in place allowing it to dissolve dirt and in this case loosen the adhesive.

After leaving it to dwell for 20 minutes I attacked it with a very coarse 100 grit diamond pad attached to a buffer machine. This removed a minuscule layer from the surface of the tile and with it the muck. I vacuumed up the excess with a wet vacuum then rubbed down the stubborn areas with a 50 grit hand block. This removed a lot of dirt and drastically lightened the whites and blues. Finally I neutralised the floor with two rinses of clean, warm water again using the wet vacuum to remove as much moisture as possible from the floor.

I repeated this process along the length of the hallway and then inspected the floor retreating any areas containing stubborn marks.

Sealing a Victorian Tiled Floor

The hallway wasn’t that big an area so I had agreed to do the whole floor in one day. As a result I needed to force dry the floor so I could seal the tiles in the same day. I have a number of tools to do this including an industrial air mover and a heat gun which were applied for about an hour before it was dry.

To seal the tiles I applied two coats of Tile Doctor Colour Grow which as its name suggests is a colour enhancing sealer that works by impregnating the pores of the tile protecting it from within and enriching the colours in the process. This gave a lovely contrast in colour whilst providing a matt finish; another advantage of Colour Grow is it’s a fully breathable sealer which won’t trap moisture under the tile which is important for these old floors where no damp proof membrane is installed.

Victorian Tiled Hallway After Restoration in Leatherhead

The Victorian tiled hallway floor now looks amazing.
 
 

Professional Victorian Tiled Hallway Restoration in West Surrey



Source link

Acid-Damaged Marble Shower Cubicle Restored in Leatherhead


Marble tiles are a fantastic choice of stone for a shower cubicle because of its distinctive characteristics and quality. It can really add a luxurious feel and when used in a bathroom take it to the next level.

However, it’s extremely important to note that Marble like all natural stone is a porous and acid-sensitive material. It must therefore be cleaned with care using suitable products. This particular Marble tiled shower cubicle at a property in Leatherhead is a good example of this done wrong. The owner had used an acid-based cleaning product to clean the stone, resulting in damage to the sealer and causing unappealing streaks to form.

Marble Shower Wall Leatherhead Before Cleaning

This type of damage can appear irreparable but, with the right combination of cleaning methods and products, it can be fixed. Once the old sealer has been removed, and the tiles have been cleaned, polished and re-sealed, they can look as a good as new. Here’s how I helped this customer restore the Marble shower cubicle.

Cleaning and Polishing a Marble Shower Cubicle

To begin the restoration, I scrubbed the dirty grout lines using Tile Doctor Pro-Clean, which is a highly reliable and multi-purpose alkaline-based product. I then rinsed the tiles with water to remove the traces of cleaning product.

Next, I moved on to the polishing stage of the restoration – what we often refer to as burnishing. This involved the use of small six-inch diamond-encrusted burnishing pads applied with a hand buffer and with different levels of grit – ranging from Coarse to Very Fine. I started with the Coarse grit pad and worked my way sequentially through our four-pad system, polishing the stone with Medium, Fine and eventually the Very Fine pad to really bring up the polish.

Sealing a Marble Shower Cubicle

Once the shine had returned to the Marble and the damage had been removed, I re-sealed the tiles using two coats of Tile Doctor Colour Grow, a penetrating sealer designed to enhance the natural colours and patina of the stone. Once dry, I gave the tiles a final polish with a white buffing pad to put the finishing touches on the restoration.

Marble Shower Wall Leatherhead After Cleaning

The customer was thrilled with the results, saying:
“I’m really happy with the result and we will make sure we don’t use supermarket cleaners again on natural stone. Rupert was a very personable tradesman who took pride in what he was doing. He has identified Tile Doctor Neutral Tile Cleaner as being the product we should have used in the first place and has sent me the website details.”
Another satisfied customer!
 
 

Professional Restoration of a Damaged Marble Tiled Shower Cubicle in Surrey



Source link