Deep Cleaning and Sealing a Beautiful Slate Tiled Kitchen Floor in Spencer’s Wood


Slate tiles do look incredible but like any natural stone you really need to maintain the sealer if you want them to stay that way. Unfortunately it’s usually the case that the sealer wears off overtime especially in the high foot traffic areas such as Kitchens and within a few years the tiles become dull with ingrained dirt.

This process happens so gradually it goes un-noticed until the floor becomes difficult to keep clean and a decision is made to have it sorted out. This was certainly the case with this Semi Riven Multicoloured Slate tiled kitchen floor at a house in the Berkshire village of Spencer’s Wood. The floor had been installed about fifteen years prior and over the years the Slate had become soiled to the point where domestic cleaners weren’t having any effect.

Slate Tiled Kitchen Floor Before Cleaning Spencers Wood Slate Tiled Kitchen Floor Before Cleaning Spencers Wood

Cleaning Dirty Slate Kitchen Tiles

To begin the restoration I soaked the tiles in a strong dilution of Tile Doctor Remove and Go and left it to dwell for about twenty minutes re-applying extra solution when it had dried. Remove and Go is our go to product for removing old coatings such as in this case sealers, although much of the old sealer had worn off it was still present in the less busy areas of the floor and to get an even final result I needed to ensure all of it was removed. Once the old sealer had started to weaken I agitated the product using a black pad fitted to a rotary buffing machine. The rotary pad struggles to reach into the recesses of the grout lines so I also made sure to scrub the solution into the grout with a grout brush.

Slate Tiled Kitchen Floor During Cleaning Spencers Wood Slate Tiled Kitchen Floor During Cleaning Spencers Wood

I suspect there were multiple layers of sealer on this floor that had been applied over the years as some areas were proving particularly stubborn. Something stronger was going to be needed particularly in the grout lines. So I applied Tile Doctor HBU remover; HBU stands for Heavy Build-Up and allowed this to dwell for thirty minutes while I cleaned other areas.

Once I was satisfied that the Slate and the Grout was clean and clear of old sealers I gave the whole floor a rinse with water using a wet extraction machine. One the soiled cleaning solutions were removed you could really see the difference that the combination of cleaning products had made.

Slate Tiled Kitchen Floor During Cleaning Spencers Wood

The final step in the cleaning process was to give the floor an Acid Wash using a mild solution of Grout Clean-up which removes any surface grout (aka grout smears) and other mineral deposits from the slate to ensure they true beauty of the stone will be visible. Once this was removed the whole floor was rinsed with water to remove any trace of product and then dried as much as possible. After a final inspection the floor was left overnight to dry off fully.

Slate Tiled Kitchen Floor During Cleaning Spencers Wood

Sealing Slate Kitchen Tiles

Returning to the property the next day, I ran some quick damp tests to check for any excess moisture that might have prevented me from sealing the floor. We will always do this as excess moisture can affect the sealer curing.

Slate Tiled Kitchen Floor During Sealing Spencers Wood

The customer was very happy with the clean and the floor was dry so we discussed sealer options to find out their preference for Matt or Satin finish. With the decision made to go with a Satin finish I began the application of the Tile Doctor Seal and Go which enhances the look of the stone with an aesthetically pleasing low-sheen finish, as well as providing on-going protection against ingrained dirt and staining.

Slate Tiled Kitchen Floor After Sealing Spencers Wood Slate Tiled Kitchen Floor After Sealing Spencers Wood

A total of five coats of Seal and Go were needed to seal the Slate tiles and as you can see from the photos the sealer really put the life back into the floor.
 
 

Rejuvenating a Semi Riven Multicoloured Slate Tiled Kitchen Floor in Berkshire



Source link

Exterior Slate Patio Paving Tile Renovation in Thatcham


Details below of a job I completed earlier in the summer in the Berkshire town of Thatcham which is just east of Newbury. The customer had a lovely Slate Patio installed the year before which had not been sealed by the builder and it had since become dull, light grey and unpleasing to the eye. Additionally there was a haze on tiles from sand and cement that had been used to point between the paving which the customer couldn’t remove.

Exterior Slate Before Renovation Thatcham

I first went round there to take a look at the job and work out a price; we often get asked to quote over the phone but it’s really difficult to do that without look at the job as you never know how things are going to work out unless you do a test clean. In this case I was able to demonstrate the process to the customer on one of the paving tiles which you can easily pick out in the photographs below.

Exterior Slate Before Renovation Thatcham

Happy with the demonstration I was given the job to do the whole patio so I arranged to a date to come back and do the work.

Cleaning Slate Patio Paving

On my return the first job was to tackle the sand and cement haze that was covering much of the slate patio. Fortunately for me the builder had not sealed the tiles so this was just a straightforward case of applying a solution of Tile Doctor Grout Clean-Up, leaving it to dwell for ten minutes and then scrubbing it into the paving with a mechanical scrubbing machine to release the sandy haze as well as breaking down the soils on the tiles.

You should be aware that Grout Clean-Up is an acid based product and Slate like most natural stone is acid sensitive so it’s important to remove it as soon as its done its job and rinse down the stone with water soon after.

To rinse the slate patio I used our specialist truck mounted systems which gently blasts the soils from the stone with hot pressurised water whilst simultaneously recapturing the waste back into a tank on the van. This action also neutralises the stones which is important before applying sealer. The Slate pavers were then allowed to dry and being a very hot day this only took a couple of hours.

Sealing a Slate Patio

After a long lunch I returned to find the Slate was dry but still looking rather grey so to restore the natural dark colours to the stone I applied a coating of Tile Doctor Stone Oil then after approximately 1 hour any excess stone oil was buffed off the tiles leaving it to fully dry off overnight.

The following day I returned to apply two liberal coats of Tile Doctor Ultra Seal which is a solvent based no-sheen, natural-look penetrating sealer that will provide the needed protection from the elements and make it easier to clean in future.

Exterior Slate After Renovation Thatcham

My customer was very pleased with the final results and left the following feedback on the Tile Doctor feedback system.

“I had my patio and path cleaned and sealed. The service from the whole team has been exemplary from start to finish and I am delighted with the work that has been carried out. My particular thanks to Dennis who was friendly, helpful and exceptionally professional. He explained everything he was going to do and why, kept me informed throughout and worked really hard to produce a fantastic finish on my patio and path. I’m really grateful and will most definitely be recommending to friends. Thank you”

Exterior Slate After Renovation Thatcham
 
 

Restoring the Look of a Slate Paved Patio in Berkshire



Source link

Restoring Damaged and Stained Original Victorian Tiles in Pangbourne


Pangbourne is a large village situated on the River Thames, about 4 miles west of Reading. The village has a long, rich history – dating back to at least the 9th century. There are still quite a number of Victorian-style houses located in the village, including one that I visited recently to carry out a Victorian tiled floor restoration.

Victorian floor Covered in Lino Pangboune Before Cleaning

This floor had been hidden, unbeknownst to the property owner, under a linoleum covering for many years. Once the owner realised there was an original Victorian floor under the linoleum they were very keen to restore it as an original feature and stripped it off to expose the tiles, however, they were heavily covered in dirty, adhesive stains and other contaminants and we were asked to complete the job. You can see this in the photos below.

Victorian floor Covered in Lino Pangboune Before Cleaning

At Tile Doctor, we are very experienced in restoring original Victorian tiles, so I was more than happy to help this customer transform her floor.

Cleaning a Dirty and Stained Victorian Tiled Floor

As I’ve mentioned, the top layer of this original Victorian tiled floor was marked with all manner of staining, so I decided that it would be suitable to use a set of 100 and 200 grit coarse Diamond pads fitted to a weighted machine and lubricated with a little water to grind away the damaged surface and restore the surface of the tiles.

I then cleaned the tiles using Tile Doctor Pro Clean, which is our reliable alkaline-based cleaner for natural stone. This product really helped to break down and release the soils. Next, I rinsed the floor with hot water under low pressure to remove any remaining debris, dirt and contamination.

With the cleaning process completed, the floor was allowed to dry for a full 48 hours. In older properties like these dampness can be an issue as damp-proof membranes are a relatively modern invention and I didn’t want to take any chances.

Sealing a Victorian Tiled Floor

Returning to the property two days later, I ran some moisture tests to ensure the stone was completely dry and could be sealed. It’s always important to run damp tests on any tiled floor before sealing, since a small amount of excess moisture can undermine the performance of the sealer, and thus expose the floor to ingrained dirt and stains.

Thankfully, the floor proved dry and I could seal it using Tile Doctor Seal and Go which, as a topical sealer, offers a robust surface seal and an aesthetically pleasing low-sheen finish. It’s also water based so it doesn’t give off a smell as it dries.

Victorian floor Covered in Lino Pangboune After Cleaning

As you can see from the after photos, the restoration returned the life and colour to this fantastic original Victorian tiled floor. The customer was absolutely thrilled with the result.

Victorian floor Covered in Lino Pangboune After Cleaning
 
 

Professional Restoration of a Dirty and Stained Original Victorian Tiled Floor Restoration in Berkshire



Source link